P48-104: Axis control

P48-104: Axis control

Motion control for 2 motor-axes (Servo and/or Stepper) with integrated digital I/Os
PC-104 format

Expansion module, applicable to all pre-set boards (e.g. P48), allowing 16 inputs + 8 opto-isolated digital outputs to be added.
These I/Os are "fast" because they are handled directly by the host board's microprocessor.
The opto-isolation of the signals allows galvanic isolation from the "field", thus ensuring maximum protection against interference and accidental failure.
The solid-state components used for the output stages provide protection against short-circuits, over-temperatures due to excessive dissipation and reversed polarity of the external supply voltage.

16 PNP opto-isolated digital inputs (24 Vdc nominal).
8 PNP opto-isolated digital outputs (24 Vdc nominal).
1 pin shared programmable input/output.
Each output can supply (current source) a maximum current of 500 mA.

The EXPANSION module is automatically recognised by the management library of the board on which it is mounted.

Consumption :
- 20 mA on + 5 Vdc (from card P48);
- xx A on +24 Vdc (field power supply);
Input absorption: 12 mA at 24 Vdc.
Field alim.range: 15..30 Vdc.

Format 100 x 120 mm.
Front Panel: Standard PC slot
- 1 x 34-pole male connector;
- (for flat connection to P48 card);
- 1 D-SUB 25-pin male connector (for connection to physical I/O and field power supply)
  .